Omega DP119-RTD Manuel d'utilisateur télécharger pdf (Page 14)

3.2 Changing the Meter Parameters

The proper combinations of jumper plugs S1, S2, S3, S4, and S5

inside the meter allow you to change various parameters of the

meter. These parameters include resolution, range, units, RTD

sensor configuration and sensor break configuration. You can

change the parameters by moving the plugs on one or several of

the jumper locations. Keep in mind that the meter is factory set

for 3-wire RTD, and for the upscale position.

Figure 3-2 shows the location of the jumper plugs S1 through S5.

Figure 3-2. Jumper Plugs S1 through S5

W1 W2 W3

TRANSFORMER

SPAN

DISPLAY

ZERO

(COMPONENT SIDE)

S2 S3

AAC

GIH

S4 S5

UNUSED PLUG POSITION

ZERO SPAN

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Pas de commentaire

Omega DP119-RTD Manuel d'utilisateur Page 14