Omega DP119-RTD Manuel d'utilisateur télécharger pdf (Page 17)

Section 3.3 Installation and Panel Mounting

Figure 3-4 shows the panel cutout dimensions, the dimensions

for the panel thickness, and the backplate for mounting the unit

in a panel. Connections will be done after mounting the unit.

1. Remove the 2 phillips screws from behind the display (you

don't have to go inside the meter) holding the rectangular

backplate to the meter. Remove the backplate and set aside.

2. Cut or punch a hole in the panel where you want the meter

to go. The panel can be as thick as 0.25" (6.4mm) to as thin

as 0.03" (0.8mm).

3. Insert the meter into the panel cutout.

4. From the rear of the panel, slide the backplate over the case

(smooth side out).

5. Install the 2 phillips screws to secure the meter in 1/8 DIN

mount. Center the meter in hole prior to tightening screws.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Pas de commentaire

Omega DP119-RTD Manuel d'utilisateur Page 17